Products: Parallel ATA to Serial ATA Bridge Boards - Parallel ATA to Serial ATA IDE-SATA04

IDE-SATA04

Parallel ATA to Serial ATA Host mode Bridge Board (1.5Gbps) featuring Jmicron JM20330 Serial ATA Controller

Parallel ATA to Serial ATA PRODUCT OVERVIEW:

IDE-SATA04 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Jmicron JM20330 Serial ATA bridge Controller. It is ideally suited for tailgate interface applications for removable-media drives CD-ROM, CD-R, CD-RW, DVD-ROM, DVD-RAM, tape drive, and hard disk drive.

Both ATA and ATAPI devices are supported using the same firmware. It allows SATA drives (Master or Slave) to be connected to ATA host controller. IDE-SATA04 provides the perfect solution for legacy ATA host controller to attach new SATA devices.

PRODUCT HIGHLIGHTS

Parallel ATA to Serial ATA Bridge Board:

Serial ATA:

• Compliant with Serial ATA 1.0
• 48-bit sector addressing

Serial ATA Connector:

• Signal + Power Female Type Connector

Parallel ATA:

• Ultra ATA/133 Parallel Interface
• 48-bit sector addressing
• Jumper for selecting Mater and Slave

Parallel ATA Connector:

• Male IDC 2X20 pin Connector

Transfer Rate:

• Supports PIO and DMA modes
• Supports bus master DMA at 1.5Gbps burst rate

DC Power Connector:

• Mini 4-pin floppy type power connector

Physical Dimensions:

• 3.97" x 1.00" (10.09cm x 2.54cm)
• Direct Connect Vertical type

OPERATING SYSTEMS SUPPORT

• Windows 98
• Windows NT 4.0
• Windows 2000
• Windows Me
• Windows XP
• Linux

KIT CONTENTS

• IDE-SATA04
• Big 4pin to floppy drive like Mini 4-pin DC Power Cable (Red, Black, & Yellow)
• USER\'S MANUAL
• 30-DAY WARRANTY